Crest Electronics CRE57074 RCC REMOTE SWITCH DEVICE 2.4 GHZ - Manual (Page 6)

Third line on the main LCD screen:
SW –1: shows the first switch and direction
SW –2: shows the second switch and direction
SW –2: shows the third switch and direction
SW –4: shows the fourth switch and direction
SW –5: shows the fifth switch and direction
M –SW: shows the multi switch OFF or ON
Forth line on the main LCD screen:
T 1.0s: shows the Time setting for all of the switch machines.
Link Ok: This indicates that there is a good radio link between the transmitter and the
Remote Switch Device
4.06V –shows the TX battery voltage
Remote Switch Device operation SU
Operate a single switch machine, SW –1:
Press the left or right arrow on the transmitter to activate the switch machine
Operate five switches individually, [SW –1, SW –2, SW –3, SW –4, SW –5,]
Press the left or right arrow on the transmitter to activate the switch machine
Press the top or bottom arrow on the transmitter to choose a switch or press the number
[1 –5] on the transmitter key pad to choose a switch.
To activate two or all five switches at the same time turn the [MULTI-SW] function
“ON” and press the right arrow to add the switch machines.
Select individual Remote Switch Device
To select a Remote Switch Device, press the Press the <<T key to scroll left and the
T>> key to scroll to the right.
SW-BUSY
When the direction button is pressed and the switch machine is in motion a switch busy
signal will show up where ‘link ok’ is. The switch busy signal will go away after all the
switch machine completes time setting. It is recommend to wait until the switch busy
signal completes and then press the other direction necessary.
Switch Machine Direction
Page 6