Cybex 525AT Arc Trainer - Manual (Page 52)

52 53
Cybex Service Manual
Upper Electronics
Contact Heart Rate Grips
Tools Required
• Phillips screwdriver
• Rubber Hammer
• Wire Cutter
• Tape
• Strain relief plier or needle nose plier
Remove grips
1. Remove the five screws securing back grip to front grip using a Phillips screwdriver.
3
4
2
1
5
Description
1 Back grip
2 Front grip
3 White (or red) heart rate wire must be on
inside (palm side
4 Black heart rate wire (shield wire) must
be on outside (finger side).
5 Screws (5)
2. Disconnect the heart rate wire from each grip.
Remove old cable and install new cable
1. Unplug heart rate cable jack (located near bottom end of arm).
2
3
1
Description
1 Remove strain relief
2 Heart rate cable
3 Unplug heart rate cable jack
2. Cut off the cable jack using wire cutters,.
3. Remove strain relief using strain relief plier or needle nose pliers.