Cybex 750AT Arc Trainer - Manual (Page 29)

Cybex Arc Trainer 750A/750AT Owner’s Manual
29
Install right handle assembly
Position the right handle assembly in the correct position on the right side where the left handle 1.
assembly was removed in step 7 of Remove left and right handle assembly.
Screw/Loctite
Washer
Pivot Pin
#21
(Both Sides–Left Side Shown)
750AT
(Both Sides–Left Side Shown)
#20
#17
#18
#19
Loctite
(#16)
NOTE: The SHCS .250-20 UNC-3A SS (#19)
must be tightened to a minimum
of 90 in/lbs.
750AT
Apply loctite (#16) 2. to threads inside the arm and screws removed in step two of Remove left and
right handles.
(Both Sides–Left Side Shown)
#20
#17
#18
#19
Loctite
(#16)
NOTE: The SHCS .250-20 UNC-3A SS (#19)
must be tightened to a minimum
of 90 in/lbs.
750AT