Delta Electronics Delta Temperature Controller DTC1000R - Manual (Page 20)

Delta Temperature Controller User Manual
2007-09-17 - 20 - © DELTA ELECTRONICS, INC. ALL RIGHTS RESERVED
Display Explanations
PV SV Status of the temperature controller
＋ Remaining time in the current step
＋ Target temperature for the current execution
＋ The pattern currently executed
ƒ Parameters relevant to PID PROG control
Press in the main screen of DTB to enter the “regulation mode”.
Display Explanations
PV SV Status of the temperature controller
The 0 th PID parameter. There are 4 groups of PID parameters
built in DTB. When the parameter is set ass PID4, the system will
automatically adopt the PID value of the current temperature
closest to PID0 ~ 3.
The 0 th SV
The 0 th default value for proportional control
The 0 th default value for integral control
The 0 th default value for derivative control
The 0 th default integral value
Heating/cooling control cycle
Temperature inaccuracy adjustment value
Press in the main screen of DTB to enter the “operation mode”.
Display Explanations
PV SV Status of the temperature controller
/ /
/
Stop/run/program stop/program hold。
Program stop: Run the system again, and DTB will start from
the initial step.
Program hold: Run the system again, and DTB will follow and
start from the previous step.