Daktronics BB-2102 Tuff Sport Four-Sided Basketball LED Scoreboard - Manual (Page 9)

Introduction 3
1.5 Daktronics Nomenclature
Most components within this display carry a white label that lists the part number of the unit.
If a component is not found in the Replacement Parts List in Section ‎5.8, use the label to order
a replacement. Figure 3 illustrates a typical label. The part number is in bold.
Main Component Labels
Part Type
Part Number
Individual circuit board 0P-XXXX-XXXX
Assembly; a collection of circuit boards 0A-XXXX-XXXX
Wire or cable W-XXXX
Fuse F-XXXX
Transformer T-XXXX
Metal part M-XXX
Fabricated metal assembly 0S-XXXXXX
Specially ordered part PR-XXXXX-X
Accessory Labels
Component
Label
Termination block for power
or signal cable TBXX
Grounding point EXX
Power or signal jack JXX
Power or signal plug for the
opposite jack PXX
Following the Replacement Parts List is the Daktronics Exchange Policy and the Repair &
Return Program. Refer to these instructions if replacing or repairing any display component.
1.6 Product Safety Approval
Daktronics Tuff Sport scoreboards are ETL-listed, tested to CSA standards and CE-labeled for
indoor use. Contact Daktronics with any questions regarding the testing procedures.
Note: The four-sided scoreboards detailed in this manual are designed to be suspended
above players or spectators, and that creates serious liability considerations. It is
imperative that the roof support system be able to bear the weight of the scoreboard and
all other attachments. Consequently, a licensed engineer must certify the roof support
system. Suspension cables and hoist or attachment structures must also be designed and
certified by a licensed engineer.
Daktronics is not responsible for structures and suspension systems designed or installed
by others.
Figure 3: Typical Label