Daktronics AE-3010-7.6-R,G,A - Manual (Page 38)

Maintenance and Troubleshooting 4-8
Cannot communicate to section of
the network of displays • Check the cabling between displays.
• Check for bad input on first bad display.
• Check for bad output on the last good
display.
• Switch the suspected bad display with
a known good display.
• Check displays and software for correct
addressing
Display is stuck on bright or dim. • Check Manual/Auto dimming in Venus
1500 software.
• Check light detector cable.
• Replace light detector.
• Replace controller board.
4.6 Initial Operation Information
Each time the display is powered up, the display will run through an initialization in
which it will display the following:
1. Output Test (DDD’s)
2. Product Name (Galaxy)
3. Display Size (Row x Column)
4. Firmware Number (ED10134)
5. Firmware Revision (Rev X.XX)
6. COM1 Configuration (C1: V15/RTD)
7. COM2 Configuration (C2: None)
8. Line Frequency (60 Hz)
9. Hardware Address (HW: XX)
10. Software Address (SW: XX)
11. Display Name
12. If Modem is Present (Modem)