Dataprobe Serial iBootBar - Manual (Page 11)

Serial iBootBar v111207e
Page 11
Device Commands
Command Description Access Fact Default
get outlets This command displays a list of connected devices, and their current
status. User
set name <name> Set the name of the selected iBootBar. 20 characters max. User
get current Gets the measured current of the iBootBar Admin
get external control Get or set external control capability. Enabling this will allow the
external inputs to control its corresponding outlet. Admin enable
set external control <enable/disable>
get cycle Get or set the cycle time in seconds. Cycle time is the time that the
outlet will be off during a reboot (on
– off – on) or on during a cycle (off
– on – off)
User 10
set cycle <1-99>
get delay Get or set the delay time in seconds. When multiple outlets are turned
On by a single command, this delay controls the interval between
powering up of the outlets. This delay is used to limit power up inrush. User 1
set delay <0-99>
get current alarm High and Low alarms are used to monitor current conditions and send
an alert via the serial port when the high or low thresholds are
exceeded.
From 0.0 to 10.0/15.0 (depending on max current for device) in 0.1
amp increments. Admin Highalarm:
10.0 for 10 Amp
Models
15.0 for 15 Amp
Models
Lowalarm:
0.0 Amp
set main a highalarm <nn.n>
set main a lowalarm <nn.n>
get logon Disabling logon bypasses the username and password requirements
and allows direct machine to machine communications. No logon
prompt will be issued. Admin Enabled
get logon <enable/disable>