DFI HD100-H81 - Manual (Page 24)

www.dfi .com
24
Chapter 2 Hardware Installation
Chapter 2
I/O Connectors
SATA (Serial ATA) Connectors
SATA 3.0 6Gb/s
SATA 1 SATA 0
7
RXN
GND
TXP
TXN
GND
1
RXP
GND
• 2 Serial ATA 3.0 ports with data transfer rate up to 6Gb/s (SATA 0 and SATA 1)
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“SATA Configuration” submenu) of the
BIOS. Refer to the chapter 3 for more information.
Features
The 8-bit Digital I/O connector provides powering-on function to external devices that are con-
nected to these connectors.
1 4
+12V
Ground
5VSB +5V
Digital I/O power
Digital I/O
Digital I/O Connector
Digital I/O Power Connector
Digital I/O Connector
Pins Function
0 DIO7
1 DIO6
2 DIO5
3 DIO4
4 DIO3
5 DIO2
6 DIO1
7 DIO0
Note:
Some 3rd party SATA Gen 2 speed device controllers used on the system board paired
with the Intel ® 8 series chipset are intermittently detected. Before using SSD devices
or mSATA SSD devices, please check whether the device and the cable which are
used on the system board conform to Intel's official regulations.