DFI HD171-H81 - Manual (Page 17)

www.dfi .com
17
Chapter 2 Hardware Installation
Chapter 2
Digital I/O Power Select
2-3 On: +5V 1-2 On: +5V_standby
(default)
JP13 is used to select the power of DIO (Digital I/O) signal.
JP13
1
3
2
1
3
2
Digital I/O Output State
Based on the power level of DIO (Digital I/O) selected on JP13, JP10 (DIO pin 0-3) and JP12
(DIO pin 4-7) are used to select the state of DIO output: pull high or pull low. When selecting
pull high, the power selection will be the same as JP13’s setting.
2-3 On: GND
(default)
1-2 On: +5V or
+5V_standby
DIO 0-3
(JP10)
DIO 4-7
(JP12)
1
3
2
1
3
2