DFI HD630-H81 - Manual (Page 25)

www.dfi .com
25
Chapter 2 Hardware Installation
Chapter 2
Audio
Rear Audio
The system board is equipped with 3 audio jacks. A jack is a one-hole connecting interface for
inserting a plug.
• Line-in/Surround Jack (Light Blue)
This jack is used to connect any audio devices such as Hi-fi set, CD player, tape player,
AM/FM radio tuner, synthesizer, etc.
• Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
• Mic-in/Center+Subwoofer Jack (Pink)
This jack is used to connect an external microphone.
Front Audio
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
Driver Installation
Install the audio driver. Refer to the chapter 4 for more information.
Rear Audio
Front
Audio
1
Mic2-L
Line2-R
Front_IO_Sense
GND Presence Signal Ke
y
2
9
Mic2-
JD
Line2-
JD
10
Mic2-R Line2-L
Line-out
Line-in/Surround
Mic-in/
Center+Subwoofer
USB 2.0
I/O Connectors
SATA (Serial ATA) Connectors
• 4 Serial ATA ports
- 2 SATA 3.0 ports with data transfer rate up to 6Gb/s (SATA 0 and SATA 1)
- 2 SATA 2.0 ports with data transfer rate up to 3Gb/s (SATA 4 and SATA 5)
• Integrated Advanced Host Controller Interface (AHCI) controller
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA data cable to a SATA connector and the other end to your Serial ATA device.
The system board package comes with a power cable that must be connected from the system
board’s peripheral power connector to the SATA drive’s power connector in order to provide
power to the drive.
Features
7
RXN GND TXP TXN GND
1
RXP GND
USB 2.0
SATA 0
SATA 1
SATA 5 SATA 4
SATA 3.0 6Gb/s
SATA 2.0 3Gb/s
(SATA port 5 provides adequate
space for SATA DOM.)