DR Power Mini Tiller Roto-Hog (January 2015 - Present) - Manual (Page 9)

CONTACT US AT www.DRpower.com 9
 Never store engine with fuel in the tank indoors. Fuel and fuel vapors are highly flammable.
 An adult only must always handle and fill the engine with fuel.
 Always handle gas in a well ventilated area, outdoors, away from flames or sparks.
 Do not start engine if fuel is spilled. Wipe off excess fuel and allow to dry. Remove engine from area to avoid
sparks.
5. Attach the Upper Right and Left Handlebars to the Middle Handlebar using the remaining two T-Handle Nuts, two
Handle Clamp Bolts, and two Curved Washers (Figure 2 on page 8). DO NOT over tighten the T-Handle Nuts.
6. The Drag Stake shipped with its pointed end facing upwards. Remove the Detent Pin, turn the Drag Stake around
and direct the point in the downward position facing towards the Tines, and then reinsert the Detent Pin (Figure 3).
7. Do not discard your packaging material until you are fully satisfied with your new DR ROTO-HOG Mini Tiller.
Adding the Gasoline and Oil
Engine is shipped from factory without oil. You must add engine oil before starting engine. If engine is started
without oil, engine may be damaged beyond repair and will not be covered by warranty.
Filling the Fuel Tank
Always fill the Fuel Tank outdoors or in a well-ventilated area, away from sparks, open flames, pilot lights, heat, and
other ignition sources.
1. Shut-off engine and allow engine to completely cool before refilling the fuel tank.
2. Move to a well ventilated area, outdoors, away from flames
and sparks.
3. Clean debris from area around the fuel cap.
4. Loosen fuel cap slowly. Prevent the cap from coming in contact with dirt or debris.
5. Carefully add fuel without spilling.
6. Do not fill gas tank completely full, allow space for fuel to
expand.
7. Immediately replace fuel cap and tighten. Wipe off spilled fuel and allow to dry before starting engine.
Note: To refill the Fuel Tank, turn the Engine OFF, and let the Engine cool at least five minutes before removing the Fuel Tank
Cap.
Figure 3