DR Power 6.0 HP Pro Power Wagon (June 2002 - January 2007) - Manual (Page 19)

POWERWAGON
™
Safety & Operating Instructions 19
Note: Turn the nut only 1/4 turn at a time, and then test the brake to see if the adjustment
worked. If needed, adjust the nut another 1/4 turn and test again.
Brake Cable Adjustment
The brake cable is factory set (Figure 19).
If you think the brake cable needs to be
adjusted, you may actually need to replace
the brake pads. See below.
To Change the Brake Pads
If your DR
®
POWERWAGON
™
rolls on
slopes when the brake is set, and you have
tried adjusting the brake, the brake pads
may need to be replaced.
Tools and Supplies Needed:
• 1/2" wrench or socket
• Mat or container for loose parts
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
Note: You may want to remove the wheel
to provide easier access to the brake area
(see page 14).
1. Find a level area to work. The parking
brake should NOT be engaged. Chock
the wheels so the machine cannot move.
2. Locate the brake caliper at the right
front of the machine (Figure 20).
Remove the two caliper bolts holding
the brake caliper with a 1/2" wrench,
then carefully remove the caliper.
Figure 19
Figure 20