DR Power 6.0 HP Pro Power Wagon (June 2002 - January 2007) - Manual (Page 24)

24 POWERWAGON
™
Safety & Operating Instructions
End of Season
!
WARNING: Always disconnect the spark plug wire before servicing your machine.
Note: See your engine manufacturer's owner's manual for care and maintenance of the engine.
Run the engine dry to empty the carburetor. Or, if you prefer, add the recommended amount
of gasoline stabilizer to the fuel in the tank. Run the engine for 2-3 minutes to allow the
stabilizer to reach the carburetor. Pull the starter handle slowly until resistance is felt due to
compression, then stop. Release starter tension slowly to prevent the engine from reversing
due to compression. This position will close both the intake and exhaust valves to prevent
corrosion of the piston and cylinder bore.
Change the oil. This will help to eliminate sludge and acids in the engine.
Electric-starting models: The battery should be removed and kept in a cool, dry place when
the DR
®
POWERWAGON
™
goes into storage. We suggest charging the battery once a
month while the DR
®
is stored and again before you are ready to start the new season. This
will help the battery maintain its charge all season.
Remove dirt and debris from the carburetor linkage, the cylinder head cooling fins, the
blower housing, the rotating screen, and the muffler area.
Check to make sure the operator controls are moving freely. Lubricate the throttle lever,
brake lever, and key switch with FLUID FILM
®
or similar lubricant if necessary.