Elfa Drawer frame, pant rack, décor fascia and accessory tray - Manual

www.elfa.com
Sida 7 av 13
Décor components
Hanging drawers, gliding accessory racks,
Décor shelves and fascia
Install hanging drawers, gliding accessory, décor shelves
and fascia before installing wire shelves.
Décor gliding components and drawer frame are all
installed with the same U-shaped metal glide.
If you would like more space between drawers, simply
move them to the desired position.
NOTE!
Install the U-Shaped metal glide
The U-Shaped metal glide has three metal tabs and
a metal knob on each side (located at the top of the
glide) that locks the glide into the bracket click in.
– Begin with the left bracket click in. Align the
metal tabs on the U-shaped metal glide with the
cutout notches of the bracket click in.
– When aligned, hold the front of the bracket and
press on the U-shaped metal glide at the back
rounded corner until you hear it lock into place.
– Repeat on the right side.
1
Reposition and remove
To REPOSITION the U-shaped metal glide: It is not
necessary to remove the glide from the brackets.
Simply tilt up the front of both brackets and remove
them from the hang standards. Place in the desired
location.
To REMOVE the U-shaped metal glide from the
brackets: Place one hand at the back of the glide.
With your thumb on the hang standard, gently push
the glide forward with your fingers.
At the same time, insert and twist a small flat head
screwdriver between the bracket and U-shaped
metal glide in front of the knob holding the glide in
place.
The U-shaped metal glide should pop out of the
bracket. Repeat on the other side.
Elfa Lumi AB
Elfagatan 5, 593 87 Västervik
Tel: +46 392-389 10 Fax: +46 392-361 25. E-mail: [email protected]