equinux VPN Tracker 5.4.4 - Manual (Page 27)

‣ Enter a name for your connection
‣ Click “OK”
You should configure the basic settings first.
Client Provisioning
Some gateways support automatic configuration of certain
parameters (like the local address, the remote network or DNS
settings).
If your VPN gateway is configured to use Client Provisioning:
‣ Check the Client Provisioning box
‣ Select the desired Client Provisioning type
If your VPN gateway is configured to use Mode Config:
‣ Check the Mode Config box
‣ Select the desired Mode Config type
Note When using either Client Provisioning or Mode
Config, the parameters sent by the gateway cannot
be specified manually.
Network
A connection can be configured for different network
topologies:
‣ Host to Host connects your Mac to a single remote
computer. You can select tunnel or transport mode, where
tunnel mode is recommended for most environments.
‣ Host to Network connects your Mac to a remote network.
This is the most commonly used topology.
‣ Host to Everywhere will send all your network traffic
through the tunnel. This mode is recommended for securing
27