ESI Miditerminal 4140 - Manual (Page 27)

26
T O G E N E R A T E S M P T E T I M E C O D E
1. Open the SMPTE Desk.
2. Select the frame rate (30, 30D, 29.97, 25, or 24)
3. Set the SMPTE time with your mouse.
4. Connect a cable from the Miditerminal 4140's SMPTE Output jack into the tape
recorder's input jack.
5. Press the Start button, and it will begin generating time code. Once you start generating
time code, you will notice now that the Start button reads Stop.
6. Press the Stop button to stop generating time code if you want to stop it.
T O S Y N C H R O N I Z E S M P T E
1. Connect a cable from the SMPTE Out of an external device (ex. tape recorder) to
SMPTE In of the Miditerminal 4140.
2. Open your application. Check ‘SMPTE-Miditerminal 4140 EWDM’ of the MIDI In
port of your application.
3. Properly set the offset time and SMPTE frame of your audio application.
4. Set your software to ‘Slave mode’ and standby.
5. Start playback of your Master Device (such as a tape recorder or VTR).