ESI NeON - Manual (Page 23)

ESI
23
Velocity Curve
Neon has 4 internal velocity curves. Default at power‐up is always 1. To change:
1. Press SHIFT + Vel. Curve.
2. Type in 1‐4. Press ENTER
Velocity curve numbers greater than 4 are invalid and will be ignored if entered.
Velocity Offset
A programmable offset can be added to the velocity generated by the keyboard. This value can be in the
range ‐64 to +64. Default at power‐up is no offset. To change:
1. Press SHIFT + Vel. Offset.
2. For positive values, first press the INC/+ button to indicate a positive value. The LED next to the
button will light up. Next, type in the value 0‐64. For negative values, first press the DEC/‐
button to indicate a negative value (LED will light up), then type in the number 0‐64.
3. Press ENTER to complete the operation.
Sustain Pedal
The Sustain Pedal input can be programmed to accept normally‐open or normally‐closed types of sustain
pedals. To switch the mode, Press SHIFT + Sus. Pedal. If you hear the notes from NeON “hanging”, you
may try to switch this to toggle the sustain mode.
Octave +/-
The NeON keyboard can be transposed up or down by pressing the OCT+ or OCT‐ buttons, respectively.