ETA Manoa Animal - Manual (Page 27)

III. VACUUM CLEANER PREPARATION
Hose
– Connect hose C2 to the vacuum cleaner by inserting the end piece to suction vent A1
to the maximum position and turn to the right (Fig. 4). You will hear a clicking sound.
– To disassemble proceed in the reverse sequence.
Telescopic tube
– You can connect tube C3 with hose handle C2 by slight pushing the handle to the tube (Fig. 3).
– You can disconnect the tube by pulling the handle slightly out of the tube.
– The telescopic tube allows setting suitable length to fit your figure. Press the lock pin in the
direction of the arrow and pull out or push in the required length of the tube (Fig. 5). When
you release the lock projection, the tube length is fixed. When pulling out, keep
the tube in safe distance from your face as the tube is very long.
Floor nozzle / turbo nozzle / narrow floor nozzle
– Connect and disconnect the accessories ( C1, C7, C8) in the same way as the tube (Fig. 2).
Floor / crevice nozzle / brush / narrow TURBO nozzle/DermoPet nozzle
– Connect and disconnect the accessories ( C4, C5, C6, C9, D) in the same way as the tube
(Fig. 3).
You can connect the appliance directly to the hose handle or to the telescopic tube.
IV. USE OF VACUUM CLEANER
Remove all packing material, take out the vacuum cleaner and the accessories. Pull out
necessary length of power cord A10 and plug the power cord into a socket. Assemble the
vacuum cleaner accessories C1, C2, C3 (Fig. 2, 3, 4). If the cleaner is fitted with telescopic
tube C3, adjust its length to fit your figure (Fig. 5). Floor nozzle C1 is designed to be used to
clean carpets or smooth flooring (Fig. 6). If the floor nozzle is fitted with a brush, pull it out
by switching over a flap when vacuuming hard floorings. You can use crevice nozzle C6 for
vacuuming places that are hard to access (Fig. 7). TURBO nozzle C9 or upholstery nozzle
C4 or brush C5 can be used to clean various types of furniture (Fig. 8, 9). Adapter DermoPet
D is intended for pet care. The vacuum cleaner can be switched on or off by pushing button
A4 marked with the symbol (Fig. 10). The suction power can be adjusted with the control
on hose handle C2 (Fig. 11) or by setting regulation A6 (Fig. 10). The minimum suction
power is recommended for fine fabrics (e.g. curtains, drapes). The maximum suction power
is recommended for floor coverings (e.g. heavy-duty carpets). After finishing work, switch
off the vacuum cleaner and unplug it from the power supply. By switching button A5 with
symbol (Fig. 10) the power cord will be wound automatically. The vacuum cleaner can
be held and carried by handle A9.
Full dust filter signaling
If the coloured field is displayed permanently on the indicator A7 (Fig. 12) while the floor
nozzle is lifted above the cleaned surface at the maximum suction power, the dust filter
must be replaced. Disregard changes on the indicator during vacuuming.
Dust filter replacement
Lift off vacuum cleaner lid A3 by pushing lock A2 to the locked position (Fig. 13). Then follow
the instructions for the respective type of a dust filter:
GB
27 / 48