ETA Manoa Animal - Manual (Page 29)

If the protection micro filter is very dirty, you can also rinse the pleated side of the HEPA filter under
lukewarm slow-running tap. Hold the filter in such a way that the pleated side points upwards and
the water flows parallel to the pleats. Hold the filter at an angle so that the water washes away
the dirt inside the pleats. Turn the filter 180° and let the water flow along the pleats in the opposite
direction. Continue this process until the filter is clean. After drying, put both micro-filter back to the
grid and to the vacuum cleaner in the opposite direction. Insert the projections on the back cover into
two holes in the vacuum cleaner cover and snap the cover.
DermoPet ADAPTeR
Mounting and removing of accessories
– slide accessory ( D2/D3/A4) into the nozzle D untill it clicks into the place. Pull on the accessory
to remove it from the nozzle D.
– Assemble the D1 accessory on the front part of the nozzle and slide it on with a slight pressure.
The accessory is assembled correctly if it moves freely. Pull on the accessory
to remove it from the nozzle.
– Use the accessory D5 in case if the vacuum cleaner has trunk hose with a diametr 32 mm.
Before the first use of we recommend to use the nozzle with switched off vacuum cleaner. It will
help the animal to get accustomed to the way of cleaning. Subsequently leave sufficient time for
an animal to be accustomed to the sound of the vacuum cleaner (better with the presence of the
owner). It will help to avoid the animal being stressed, nervous, irritated, etc.
Setting of the vacuum cleaner suction power is depended on the individual assessment of the
animal‘s skin/hair dirtying. During the cleaning performance of vacuum suction can be smoothly
changed.
– maximum performance – for severely dirtying long hair / skin
– medium performance – intended for routine care of hair / skin
– minimum value – for short hair / skin with no visible dirtying, as a preventive measure against
dangerous types of allergens
According to the type / length of hair / skin and its dirtying choose the most appropriate accessory
for the nozzle. Gently attach the nozzle to the body of the animal at an optimum angle and clean it
with smooth movements. We recommend starting from the sides of the chest, neck and gradually
move through the abdomen to the rear extremities. Clean the nozzle if it is clogged with hair and
other dirts. According to your animal behavior during the cleaning you can change the accessories
of the vacuum cleaner and its suction power.
Repeated use of this nozzle is unlimited. It depends on the general assessment and experiences
of the owner, based on breed of the animal, hair type, environment in which the animal lives, the
level of dirtying, etc. Multiple and repeated use does not cause damage
to the skin and hair of the animal.
ATTeNTION
In case if your animal has a health problems (for example, dermatological disease), contact
and consult your veterinary first before using the appliance. Visit your doctor in case if
anyone of your family feels indisposition, or contact the dermatologist in case of need.
!
Storing accessories
The accessories, the floor nozzle, the suction tubes and the hose can be dismantled again or left
assembled and hung on the back side or on the bottom of the vacuum cleaner into the storage
position (Fig. 20). For better stability, slide individual parts of the tube to each other so that the
tube is as short as possible. When storing, always set the floor nozzle to the carpet position (i.e.
with the brush retracted); thus you will prevent bending of the bristles.
GB
29 / 48