Fenix ELSR-M User Manual
Page 6
3. b) Installation
• The heating cable and the sensor must be attached to the pipe along the whole
length with aluminium self-adhesive tape, which will ensure an even distribution
of heat.
• In the case of the protection of plastic pipes, it is necessary to wind the self-
adhesive aluminium tape along the pipe, and wind the aluminium tape around the
whole length of the cable after laying as well.
• After the installation, it is necessary to wrap the whole pipe, including the heating
cables, in insulation.
• During the installation, it is necessary to take into consideration that valves,
connectors and flanges have higher heat loss. Therefore, it is necessary to wind
the cable more densely in these parts.
3. c) Regulation
From the point of view of energy-saving operation, it is necessary to equip the
installation with a thermostat with a distant probe placed on the pipe. From the current
FENIX range, we recommend the KABLOREG A1-4, OJ ETV or EBERLE ITR3.
4. WARRANTY, COMPLAINTS
The supplier of the self-regulating cables provides a warranty of their functionality for a
period of 24 months from the day of their installation confirmed on the certificate of
warranty (the installation must be carried out within a maximum of 6 months after the
date of purchase), if:
• the certificate of warranty and proof of purchase are available,
• the procedure described in these instructions is followed,
• information about the laying of the cable, its connection and the results of the
measurements of the insulation resistance of the heating cable is available.
Any complaint shall be raised in writing with the company which carried out the
installation, or directly with the manufacturer.
Providing that the above-mentioned conditions are fulfilled, and after the expiry of the
warranty period, conditions set in the rules for complaints apply for the period of the
next 8 years, point No. 5.
The rules governing complaints can also be found on