Fenix KD-E - Manual (Page 2)

1. Product description

These electric bathroom units are intended for the local heating of bathrooms, corridors,
WCs, kitchenettes, etc. and also for the drying of towels, dish towels and textiles, which
can be hung on the unit.
2. Technical parameters

Wattage of the electric heating element: see the heating element’s warranty certificate

Operating voltage: 230 V

Temperature limiter: the device is switched off at a temperature of 85ºC (the maximum
temperature of the liquid inside the unit)

Rating: IP65

Freezing point of the liquid inside the unit: -5ºC
3. Installation instructions

All radiators are hung on the wall with the help of plastic brackets attached over the tubes.
Place the brackets onto the radiator on the second tube from the top and the second tube from
the bottom, approximately 30 – 50 mm from the vertical bars. Smaller types of radiator only
require 3 brackets (two for the top and one on the second tube from the bottom, in the
middle).
Mounting of the plastic brackets:

Remove the horseshoe-shaped component from the bracket (position 1)

Place the body of the fixing bracket (position 2) against the tube at the intended location and
draw in the horseshoe-shaped component (position 2), tightening the screw and nut slightly
(position 4, 5)

Mark the holes for wall plugs on the wall.

Drill holes with a diameter of 10 mm to a depth of 55 mm.

Attach the rear part of the bracket (position 3) to the wall using a screw, base and wall anchor
(position 7, 8, 9).

Slide the radiator with the attached parts of the fixing bracket (position 1, 2) into the part
(position 3) which is attached to the wall.

Fix with screws (position 6).