Fire Magic 3592 Ice Maker - Manual (Page 2)

2 NO. L-C2-31008 REV 1 - 0812231259
WARNING: FOLLOW THESE BASIC PRECAUTIONS TO REDUCE THE RISK OF FIRE, ELECTRICAL
SHOCK, OR INJURY WHEN USING YOUR ICE MAKER.
• DANGER: RISK OF CHILD ENTRAPMENT. Junked or abandoned appliances are dangerous.
• BEFORE YOU THROW AWAY YOUR ICE MAKER: take off the door.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean ice maker parts with flammable fluids. The fumes can create a fire hazard or
explosion.
• Do not store or use gasoline or any other fl ammable vapors and liquids in the vicinity of this or any
other appliance. The fumes can create a fi re hazard or explosion.
IMPORTANT SAFETY INFORMATION
BEFORE USING YOUR ICE MAKER
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
- 1 ice bucket
- 1 plastic scoop
- 1 hose, 25 ft.
• Before connecting the ice maker to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
INSTALLATION
• This appliance is designed for under-counter cabinet installation (may use Fire Magic part number
3809AR trim kit).
• Place your ice maker on a level surface that is strong enough to support the ice maker when it is fully
loaded. Remember that the unit will be signifi cantly heavier once it is operational and fully loaded.
Level your ice maker by adjusting the legs at the front of the ice maker.
• Locate the ice maker away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the fi nish and heat sources may increase electrical consumption. Extreme
cold ambient temperatures may also cause the ice maker to malfunction.
• Avoid locating the ice maker in moist/humid areas. Too much moisture in the air will cause frost to
form quickly on the evaporator requiring frequent defrosting.
• Plug the ice maker into a dedicated, properly installed grounded wall GFI outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certifi ed electrician.