Fire Magic 3592 Ice Maker - Manual (Page 3)

3 NO.L-C2-31008 REV 1 - 0812231259
ELECTRICAL CONNECTION
WARNING: IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF
ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY
AN AUTHORIZED SERVICE PERSON.
• This ice maker should be properly grounded for your safety. The power cord of this ice maker is
equipped with a three-prong plug which mates with standard three prong wall GFI outlets to minimize
the possibility of electrical shock.
• Do not under any circumstances cut or remove the third ground prong from the power cord
supplied.
• Do not use an extension cord to connect power to the unit.
• Do not use a two-prong grounding adapter.
• If you only have a two-prong wall receptacle, contact a qualifi ed electrician to have it replaced with
a 3-prong GFI receptacle in accordance with applicable electrical codes.
• This ice maker requires a standard 115 volts A.C. 60hz electrical GFI outlet with three-prong
ground.
• The cord should be secured behind the ice maker and not left exposed or loose.
EXTENSION CORD
Important: Because of potential safety hazards, this appliance is not recommended for use with an
extension cord. However, if you must use an extension cord, use only a UL/CUL-listed,
3-wire grounding type appliance extension cord with a grounding type plug and GFI outlet.
The electrical rating of the cord must be 115 volts and at least 10 amps.
CONNECTING THE WATER SUPPLY
WARNING: IMPROPER WATER LINE CONNECTION MAY RESULT IN FLOODING. YOU MUST USE
A LICENSED PLUMBER. REVIEW STATE AND LOCAL PLUMBING CODES BEFORE
INSTALLATION.
• All the necessary hardware is not provided (as the plumbing fi xtures at the installation point may
differ) for installation so it is necessary to hire a professional licensed plumber to complete the
installation.
• Connect tubing (supplied with unit) to the nearest cold water source.
Have suffi cient tubing to allow unit to be moved freely for cleaning and
service. Also make sure that the tubing is not pinched or damaged during
transportation and/or installation.
• Position unit to allow airfl ow through the front grill (see Fig. 3-1).
• Wipe the inside of unit and ice bucket with a damp cloth.
INSTALLATION (cont.)
Fig. 3-1
Do not block.