Flowserve KW941 - Manual (Page 5)

KW941 Pump Power Monitor USER INSTRUCTIONS ENGLISH 71569285 02-12
Page 5 of 24 flowserve.com
1.7 Nameplate and safety labels
1.7.1 Safety labels
1.8 Specific machine performance
For performance parameters see section 1.5, Duty
conditions. Where performance data has been supplied
separately to the purchaser these should be obtained
and retained with these User Instructions.
2 TRANSPORT AND STORAGE
2.1 Consignment receipt and unpacking
Immediately after receipt of the equipment it must be
checked against the delivery/shipping documents for
its completeness and that there has been no damage
in transportation. Any shortage and/or damage must
be reported immediately to Flowserve Pump Division
and must be received in writing within ten days of
receipt of the equipment. Later claims cannot be
accepted.
Check all crates, boxes or wrappings for any
accessories or spare parts that may be packed
separately from the equipment or attached to side
walls of the box or equipment.
The current senor (toroid) is shipped inside
the KW941 underneath the wiring compartment
cover.
2.2 Handling
The KW941 Power Monitor is small and light so
handling and mounting are easy. The unit weighs
approximately 2.3 kg (5 lbs).
2.3 Storage
Store the pump in a clean, dry location
away from vibration. If kept in its original packaging
and protected from excessive environmental effects
like continuous high humidity or corrosive gases the
shelf life would be decades.
2.4 Recycling and end of product life
At the end of the service life of the product or its
parts, the relevant materials and parts should be
recycled or disposed of using an environmentally
acceptable method and in accordance with local
regulations. If the product contains substances that
are harmful to the environment, these should be
removed and disposed of in accordance with current
local regulations. This also includes the liquids
and/or gases that may be used in the "seal system"
or other utilities.
Make sure that hazardous substances are
disposed of safely and that the correct personal
protective equipment is used. The safety
specifications must be in accordance with the current
local regulations at all times.