Flowserve MT Bevel Gearboxes IOM - Manual (Page 8)

Limitorque MT Series FCD LMENIM4201-00 – 06/10
8
Figure 2.1 – MT Nameplate
2.3 Storage Procedure
NOTE: The following is the recommended storage procedure to retain maximum product integrity
during storage. Failure to comply with recommended procedure will void the warranty.
Storage (Less Than One Year)
Operators should be stored in a clean, dry, protected warehouse and should be stored on wooden
skids to protect the machined mounting flange. If the operators must be stored outside, they must be
covered in polyethylene protection with silica gel crystals to absorb moisture. Input shafts should be
rotated every three months to mix lubricant.