Fluke Biomedical 05-434 - Manual (Page 8)

Nuclear Associates 05-434
Operators Manual
2-2
2.4 Grounding
If it is desired to ground the instrument with a separate ground wire, as required under certain codes,
Figure 2-1 shows how to accomplish this. Remove the back cover by loosening the single screw in the
center of the cover. Note the position of the ground terminal in Figure 2-1. Attach the wire by running it
up through the small hole between the jacks. Wire used for this purpose should be at least a #16 gauge.
Figure 2-1 Installation of Ground Wire