Fluke Biomedical 37-720 - Manual (Page 11)

Maintenance
Battery Replacement
3
3-1
Section 3
Maintenance
3.1 Battery Replacement
If the LO BAT message appears on the display, the battery should be replaced. Turn the power off.
Open the battery compartment (located on the rear panel). Pry on the rippled side to open the door and
gain access to the battery. Remove the old battery and replace it with a new one. When disconnecting
or reconnecting a battery, take care not to damage the connector as it is attached to short leads.
3.2 Diode Cleaning Instructions
The diodes may be cleaned with an alcohol swab or any disinfectant, which is commonly used in hygienic
care.
Figure 3-1. Component Layout Diagram (160010)
(Reference only, not to
scale)