Formax FD 2052 Operator Manual, 4th Edition - Manual (Page 7)

5
Figure 3c
1. To enter the Autobatch mode press the “Batch
Count” button and select “AUTOBATCH” by pressing
the “-” button (Fig 3a).
2. Once you have entered the Autobatch mode press
the “+” or “-” button and “Sheets” (Fig. 3c) will blink.
Press the “+” or “-” buttons to increase or decrease the
number of sheets to be pulled.
3. When the sheet number is set wait 5 seconds and
“Sets” (Fig. 3c) will blink. Press the “+” or “-” buttons
to increase or decrease the number of sets to be
pulled.
4. When the number of sets has been selected wait 5
seconds and “Delay” (Fig. 3c) will blink. Press the “+”
or “-” buttons to increase or decrease the time delay
between the sets.
5.When the settings are correct press the “Start/Stop”
to start.
NOTE: The system will cycle through the settings until
the “Start/Stop” button is pressed.
NOTE: If a fault occurs during a set, the set will be
completed when the fault is reset.
NOTE: The batch counting program selected will
remain on after the job is processed. You must press
the Batch Counting button to turn off the light and
cancel the batch count setting.
“Sheets” = Number of sheets of paper in a set
“Sets” = Number of sets to be processed
“Delay” = Time between each set
“C” = Total number of sheets processed
Figure 3b
DAILY MAINTENANCE
1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding and sealing. This
allows toner to set on the forms, and static electricity to discharge. A 400 Series Jogger is recommended for
best results. The Jogger squares the forms and dissipates heat and static electricity created by laser printers.
2. If toner builds up on the metal sealer rollers, clean the rollers with a lint-free cloth dampened sparingly with a
mild household cleaner.
3. Clean in-feed wheels and fold rollers with Formax recommended roller cleaner & rejuvenator to remove
paper dust and toner. A damp cloth with water is the best alternative. CAUTION: Do not use any chemicals
other than the roller cleaner & rejuvenator or water.