Set-up – Formax FD 280-10 User Manual

Page 9

Advertising
background image

4. SET-UP

WARNING

KEEP LOOSE CLOTHING, TIES, SCARVES AND
HAIR AWAY FROM ALL MOVING PARTS. DO NOT
PLACE FINGERS OR TOOLS BETWEEN OR NEAR
MOVING PARTS.

WARNING

THE FD 280-10 IS A HEAVY MACHINE. USE

PROPER LIFTING TECHNIQUES



4.1 Feeder

Assembly


The Feeder is shipped disassembled. Carefully remove all
components from its shipping container. Save the
container until you are satisfied that the Feeder is
operating correctly. Report any shipping damages to the
carrier.

.

1. Screw 4 aluminum risers (feet) to the machine by

inserting the long 10-32 screws through the feet and
the risers, then into the machine. Tighten evenly until
the heads of the screws are fully inside the feet.

2. Remove the screws from the ends of the paper stop

assembly and slide the assembly into the mounting
grooves between the side frames. Line the holes in
the side frame up with the holes in the paper stop and
screw them together.

3. Attach the Tail Support bar to the cross bracket in the

feed hopper.

4. Attach the Output Roll assembly by inserting the spring

loaded end of the rod in the hole closest to the
operator and carefully rotating the flatted end of the
shaft until it lines up with the flats and inserts into the
opposite end. The spring tension holds the roller in
place.

.



Advertising