Formax FD 404A1 Operator / Parts Manual - Manual (Page 8)

4
Using the Timer
1. Set Timer switch to on (I).
2. Turn the Timer Adjustment Knob to the desired length of time you wish to jog. Choose from 0 to 60 seconds.
3a. Standard operation: Set the timer switch to the on position and set the three way switch to the on position, air
llow and vibrations begin when the is stepped on. Jogging and air flow will stop when the set time has passed.
3b. Foot Pedal operation: Set the timer switch to the on position and set the three way switch to FOOT, air flow
and vibrations begin when the foot switch is stepped on. Jogging and air flow will stop when the set time has
passed.
TROUBLESHOOTING
TROUBLE POSSIBLE CAUSE REMEDY
Paper is not jogged
completely
Paper is a non-standard size Jog it while loosening it by hand.
Paper has static electricity Add some space between the sheets by
hand.
Too much paper in paper tray Reduce the volume of paper jogged at one
time.
Air flow is weak Air adjustment knob is set to
low volume
Turn knob to the right to increase air flow.
Paper or paper scrap is lodged
in air inlet or outlet
Clear air inlet and/or outlet.
If air flow problem is not fixed following these suggestions, blower
maintenance may be required. Call for service.
No air is discharged Air adjustment knob is set to
OFF
Turn knob to the right to increase air flow.
Fuse is blown Replace Fuse
If the fuse is blown again after replacement, the cause may be within the
machine. Call for service.
Paper tray will not vibrate Jogger adjustment knob is set
to OFF
Turn knob to the right to increase vibrations
Fuse is blown Replace Fuse
If the fuse is blown again after replacement, the cause may be within the
machine. Call for service.
Clean the air outlet vents in the paper tray to remove paper scraps or dust.
DAILY MAINTENANCE