Desa CF26NR - Manual (Page 9)

105443-01E
For more information, visit www.desatech.com For more information, visit www.desatech.com
9
9
INSTALLATION
Continued
MANTEL CLEARANCES FOR BUILT-IN
INSTALLATION
NOTICE: If your installation does not meet the mini-
mum clearances shown, you must do one of the
following:
• raise the mantel to an acceptable height
• remove the mantel
NOTICE: Surface temperatures of adjacent walls and
mantels become hot during operation. Walls and
mantels above the firebox may become hot to the
touch. If installed properly, these temperatures meet
the requirement of the national product standard.
Follow all minimum clearances shown in this manual.
If placing mantel above built-in fireplace, you must meet minimum
clearance between mantel shelf and top of fireplace opening.
13" 16" 19" 21"
2 1/2"
6"
8"
10"
Minimum Non-
Combustible
Material
Figure 8 - Minimum Mantel Clearances for Built-In Installation
Mantel Shelf
Note: All vertical
measurements are
from top of fireplace
opening to bottom of
mantel shelf.
REMOVING BRICK LINER RETAINER
1. Using Phillips screw driver, remove 2 screws attaching brick
liner retainers to vertical sides.
2. Remove brick liner retainers and discard. Replace 2 screws
into vertical sides.
ASSEMBLING BRASS TRIM
(Brass trim shipped with mantel)
1. Remove packaging from three pieces of brass trim.
2. Locate two adjusting plates with set screws, and two shims in
the hardware packet.
3. Align shim under adjusting plate as shown in Figure 9.
4. Slide one end of adjusting plate/shim in slot on mitered edge
of top brass trim (see Figure 9).
5. Slide other end of adjusting plate/shim in slot on mitered edge
of side brass trim (see Figure 9).
6. While firmly holding edges of brass trim together, tighten both
set screws on the adjusting plate with slotted screwdriver.
7. Repeat steps 1 through 6 for other corner.
8. Set brass assembly aside for later installation.
Figure 9 - Assembling Brass Trim
Top
Brass
Trim
Side
Brass
Trim
Mitered
Edge
Shim
Set Screws
Adjusting
Plate
Slot
Slot
OPTIONAL MANTEL INSTALLATION
Note: Refer to instructions provided with the mantel for assembly
instructions. Refer to instructions below for system installation. If
using blower accessory (see Accessories, page 31), see installation
instructions on pages 10 and 11.
1. Choose location for fireplace and install gas supply line.
2. Remove screen from fireplace by removing screws in each
end of screen rod (see Figure 10). Hold screen rod cover while
removing five hex head screws underneath hood (see Figure
11, page 10). Carefully lift and pull out hood (see Figure 12,
page 10).
Figure 10 - Removing Screen
INSTALLATION
Mantel Clearances For Built-In Installation
Removing Brick Liner Retainer
Assembling Brass Trim
Optional Mantel Installation