GAMMA PROGRESSION ST (Issue 2 / Version E - Oct. 28, 1997) - Manual (Page 4)

3
Installing the Tensioner
Remove the button head screw and washer
located at the end of the tensioner bar with
the 3 mm hex wrench provided. Slide the
tensioner onto the bar, being careful to align
the bar with all of the bearings and the drive
gear with the gear track. Replace the set
screw and washer into the end of the tensioner
bar.
Note: The tensioner bar is equipped with a
tensioner travel stop to limit travel of the
tensioner along the bar. See page 7 for more
details about this feature.
ASSEMBLY INSTRUCTIONS
Installing the Turntable
The turntable is located on top of the foam
packing in the the shipping carton.
Insert the center post of the turntable into the
bushing located in the top of the tensioner bar
post.
Machine Base Setup
Remove all parts from the shipping cartons.
Set the base with attached tensioner bar onto
a table or floor.
When purchased with the optional floor stand,
it is more convenient to attach the base to the
floor stand at this point. See instructions
provided with the optional floor stand.