GAMMA PROGRESSION ST (Issue 2 / Version E - Oct. 28, 1997) - Manual (Page 7)

6
MOUNTING THE FRAME
Adjusting the Frame Support Posts
Place the racquet frame over the center
posts and onto the frame support. Loosen the
lever lock bolt on one support post. Slide the
post outward until the center support of the
racquet support slide is positioned near the
inside surface of the racquet frame. Securely
tighten the lever lock bolt.
Adjust the opposite post using the same
procedure.
Caution: To avoid racquet damage, the cen-
ter posts should not contact the racquet prior
to fixing the support posts.
Adjusting the Frame Shoulder Supports
Being sure the shoulder supports are free to
swivel in thier mountings, simultaneously
rotate the shoulder support adjustment knobs
clockwise until both shoulder supports gently
and squarely contact the frame.
Tighten the Frame Support Slides at the
head and throat of the racquet until they
gently contact the frame between the two
center main string grommets.
Securing the Frame
Lock the shoulder supports in position by
turning the knob at the base clockwise.
Repeat the adjustment procedure for the
remaining support post.
Re-tighten all of the frame supports in the
same order as before.
Do not overtighten any of the supports as
racquet damage may occur.
The supports should be tightened to the point
where the racquet frame will not move in the
mounting system when the handle is grasped and attempts are made to move it. Should any
supports lose contact with the frame while stringing, they should be re-tightened.