GamuT D3i - Manual (Page 6)

6
D 3i
Placement
The D 3i will get hot during use. It is important that it has free space all around the player, especially
sides and the top.
Please make sure that there is at least 10 cm (4 inches) of free space all around the preamplifi er.
Connecting to the mains
Your D 3i has been especially made for the country to which it has been shipped. Any attempt to
change the voltage or other types of modifi cations should be considered unsafe and may cause dam-
age to both the amplifi er and any connected equipment. Warranty is annulled by any form of modifi -
cation performed by any person not authorised by GamuT.
Connect the D 3i to the mains supply with the supplied IEC mains cable.
For further improvements to the level of sound quality, various types of mains cable type may be
tested. Like the importance of any other cable in the system, the quality and refi nement of the
mains cable has an infl uence on the total balance of the sound. Please feel free to experiment with
the various brands available in your country. Please note that GamuT cannot accept responsibility
for damage incurred due to improper usage, connection, or manufacture of other cables than the
enclosed.
The mains switch is located underneath the amplifi er’s front right corner. When the amplifi er is
switched on, the display will light up and you will hear two small clicks from inside the amplifi er.
Connecting to other equipment
The GamuT D 3i features several types of in and outputs:
Inputs
Four unbalanced inputs:
RIAA
Tuner
HTH
Tape
One balanced input
CD
Please note that all connectors of the D 3i are gold plated . This is done to ensure long lasting and
stable connections. Do only use cable and connectors either gold or silver plated.
•
•
•
•
•