Gladiator GAFP32CBZM New Gladiator Floor Pack - Manual (Page 5)

5
Edge Trim Installation
Insert the edge trim by joining the male tabs to the connecting female
loops. Connect the corner edge trim as shown.
TILE FLOOR CARE
Your tile floor should last for years with proper care and maintenance.
IMPORTANT:
■ Sweep the tile floor as needed, to remove surface dirt, sand,
rocks and other abrasive material that may scratch or cut the
surface finish.
■ Periodically, wash the tile floor with a mild soap and water
solution. Use a soft scrub brush to remove ground-in dirt or
stains. Do not use a hard scrub brush. Excessive scrubbing will
cause damage to the surface finish.
■ If desired, the tile floor can be separated and moved to the
driveway to be cleaned and dried. It is normal for moisture to
appear between the tile floor and the garage floor. If desired,
remove the tile floor from the garage floor and allow the floor to
dry.
NOTE: Temperatures ranging from 0°F to 120°F (-18ºC to 49ºC)
will have no adverse effect on the tile floor.
■ Periodically, it may be necessary to separate the installed tile
floor in order to remove a damaged tile or to remove sections of
installed tiles for cleaning.
1. To separate tiles start at the left leading edge of the row.
2. Lift up in the center of the tiles pulling up on the right while
pushing down on the left. This will unsnap the connection.
Separate the row of tiles.
NOTE: Be sure to install the replacement tile male tabs/female
loops in the same orientation as the removed tile.
A. Male tabs
B. Female edge trim
C. Corner edge trim
D. Male edge trim
E. Female loops
A
B
C
E
D
A. Leading edge
B. Damaged tile
A
B