Gladiator GAWB0xMTZG Adjustable Height 4/6/8 ft. Maple Workbench - Manual (Page 6)

6
5. Screw in the leveling legs (P6).The leveling legs (P6) have a flat
side designed for use with an adjustable wrench, if needed.
IMPORTANT: To install the leveling legs (P6), turn clockwise a
minimum of 1
¹⁄₂" (3.8 cm) (12 full turns). Further adjustment can
be made ³⁄₄" (1.9 cm) up or down from this position or until the
leveling leg cannot be turned any further against the bottom of
the inner leg (P2).
NOTE: Before setting workbench upright, verify that the same
number of adjustment holes are visible on each leg to ensure that the
workbench will be level.
Complete the Assembly
1. Using two or more people, stand the workbench upright and
place it in its final location.
2. Adjust the leveling legs as needed.
Workbench Care
1. Wash the workbench with a mild detergent and warm water. Do
not allow water to remain on the workbench for any length of
time.
2. Rinse completely and dry thoroughly.
P1
P1
P2
P2
P2
P2
P1
P1
P4
P3
P6 P6
P6
P6
WARNING
Excessive Weight Hazard
Use two or more people to move and assemble
workbench.
Failure to do so can result in back or other injury.