Harken C8436 MKIV Jib Reefing & Furling - Manual (Page 11)

Tighten screws into connector holes. Make
sure that a drop of adhesive was put in
screw holes. If not, apply to screw.
Use bushings, connector, wedge and
adhesive in other screw hole and
insert into other foil. Use 1 - 1 1 /
4
ml
of adhesive.
Inject only a small amount. A Unit 3 will
only take 1 to 1 1 /
4
ml graduation mark.
Tip: When you see a small amount of
adhesive enter one of the screw holes
stop. You have applied enough adhesive.
Use “ml”
marks to
estimate 1
to 1 1 /
4
ml of
adhesive Stop when you see a small
amount of adhesive enter
one of the sdrew holes.
Assembly Foils/Connectors
4/18/07 Nautor MKIV Furling 11