Dell INFINISCALE III M2401G - Manual (Page 11)

M2401G 20Gb/s InfiniBand Blade Switch I/O Module User Manual
Mellanox Technologies Rev 1.8
11
8. Equipment Disposal
9. Local and National Electrical Codes
2.2 Mechanical Installation
These switches are hot pluggable. It is not necessary to power down the Dell Chassis to install a
new switch or to replace an old switch with a new one.
Figure 4: Rear View of the Dell PowerEdge M1000e Chassis
Note: M2401G blades are not allowed in the Fabric A slots.
2.2.1 Removing an Old Switch From the Chassis
1. Remove any locking cables or screws that secure the old switch into the chassis.
2. Disconnect all of the InfiniBand cables from the front of the switch to be removed.
Disposal of this equipment should be in accordance to all national laws and regulations.
This equipment should be installed in compliance with local and national electrical
codes.
Latch Release Buttons
Locking Arms
Channel 2 slots
C2 B2 A2
Channel 1 slots
A1 B1 C1