Hummer 2006 H2 - Manual (Page 434)

5. Push and pull on the jack and retighten if necessary
to make sure the jack is secure.
6. Place the tools in the tool bag.
7. Make sure nothing is located under or in front of the
seat and then lift the rear driver’s seat so that the
floor is exposed. See 60/40 Split Bench Seat
on page 1-6 for more information.
8. For the jack A tool bag, place the narrow end of the
tool bag under the seat rails as shown and slide the
tool bag under the rear seat.
For jack B tool bag, place the narrow end of the tool
bag under the seat rails as shown and slide the
tool bag under the rear seat.
Be careful not to pinch the seat cables or electrical
harnesses.
9. Reinstall the strap to the seat rail for the jack B
tool bag. Jack A Tool Bag
Jack B Tool Bag
5-104