IBASE SI-28 - Manual (Page 35)

35
Load Fail-Safe Defaults
This option allows you to load the troubleshooting default values permanently stored
in the BIOS ROM. These default settings are non-optimal and disable all
high-performance features.
Load Optimized Defaults
This option allows you to load the default values to your system configuration. These
default settings are optimal and enable all high performance features.
Set Supervisor Password
These two options set the system password. Supervisor Password sets a password
that will be used to protect the system and Setup utility. User Password sets a
password that will be used exclusively on the system. To specify a password, highlight
the type you want and press <Enter>. The Enter Password: message prompts on the
screen. Type the password, up to eight characters in length, and press <Enter>. The
system confirms your password by asking you to type it again. After setting a
password, the screen automatically returns to the main screen.
To disable a password, just press the <Enter> key when you are prompted to enter
the password. A message will confirm the password to be disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
Save & Exit Setup
This option allows you to determine whether or not to accept the modifications. If you
type “Y”, you will quit the setup utility and save all changes into the CMOS memory. If
you type “N”, you will return to Setup utility.
Exit Without Saving
Select this option to exit the Setup utility without saving the changes you have made
in this session. Typing “Y” will quit the Setup utility without saving the modifications.
Typing “N” will return you to Setup utility.