IBASE SI-62 - Manual (Page 15)

Copyright © 2013 IBASE Technology Inc. All Rights Reserved.
13 IBASE Technology Inc.
2.2 Installing the Memory
The IB902A board supports two DDR3 memory sockets for a maximum total memory
of 16GB in DDR3 SO-DIMM memory type.
Installing and Removing Memory Modules
To install the DDR3 modules, locate the memory slot on the board and perform the
following steps:
1. Hold the DDR3 module so that the key of the DDR3 module aligned with that on the
memory slot.
2. Gently push the DDR3 module in an upright position until the clips of the slot close to
hold the DDR3 module in place when the DDR3 module touches the bottom of the slot.
3. To remove the DDR3 module, press the clips with both hands.