IBASE SI-64 - Manual (Page 13)

Copyright © 2013 IBASE Technology Inc. All Rights Reserved.
11 IBASE Technology Inc.
2 HARDWARE INSTALLATION
2.1 Installing the CPU
To install the CPU, unlock first the socket by pressing the lever sideways, then lift
it up to a 90-degree. Then, position the CPU above the socket such that the CPU
corner aligns with the gold triangle matching the socket corner with a small triangle.
Carefully insert the CPU into the socket and push down the lever to secure the CPU.
Then, install the heat sink and fan.
NOTE: Ensure that the CPU heat sink and the CPU top surface are in total contact to
avoid CPU overheating problem that would cause your system to hang or be
unstable.
2.2 Installing the Memory
The IB964 board supports four DDR3 memory socket for a maximum total memory of
32GB in DDR3 DIMM memory type.
Installing and Removing Memory Modules
To install the DDR3 modules, locate the memory slot on the board and perform the
following steps:
1. Hold the DDR3 module so that the key of the DDR3 module aligned with that on the
memory slot.
2. Gently push the DDR3 module in an upright position until the clips of the slot close to
hold the DDR3 module in place when the DDR3 module touches the bottom of the slot.
3. To remove the DDR3 module, press the clips with both hands.