Desa VMH10TNC - Manual (Page 17)

www.desatech.com 112462-01B 17
3
2
1
Figure 19 - Installing Blower (Thermostat Unit Shown)
Blower Bracket
Assembly
Screw
Wire Harness
Plastic
Wire
Strap
Wire
Harness
Switch
Plate
Switch
Outlet
Receptacle (not
included)
Power Cord
Lower Louver
Door
Blue
Red
Black
Clamp
Connector
(not included)
INSTALLATION
Continued
Figure 20 - Folding Anchor
CONNECTING TO GAS SUPPLY
WARNING: This appliance re-
quires a 45° male flare fitting 5/8"-
18 UNF (Unified National Fine
Thread) inlet connection and the
flexible gas line provided.
WARNING: A qualified ser-
vice person must connect fire-
place to gas supply. Follow all
local codes.
WARNING: Never connect
natural gas fireplace to private
(non-utility) gas wells. This gas
is commonly known as well-
head gas.
ATTACHING WOOD BASE TO
SOLID FLOOR
For attaching base to solid floors (concrete or
masonry)
Note:
Floor anchors and mounting screws are in
hardware package. The hardware package is pro-
vided with fireplace.
1. Drill holes at marked locations using 5/16"
drill bit. For solid floors (concrete or ma-
sonry), drill at least 1" deep.
2. Fold floor anchor as shown in Figure 20.
3. Insert floor anchor (wings first) into hole. Tap
anchor flush to floor.
4. Insert mounting screws through base and into
floor anchors.
5. Tighten screws until base is firmly fastened
to floor.