Desa VMH10TNC - Manual (Page 27)

www.desatech.com 112462-01B 27
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Fireplace
1. Turn control knob clockwise
Clockwise
to the
OFF position.
2. If Using Optional Hand-Held Remote: Set
remote switch to the OFF position to pre-
vent draining battery.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise
Clockwise
to the
PILOT position.
2. If Using Optional Hand-Held Remote: Use
remote control manual OFF button.
WARNING: Make sure re-
mote sensor selector switch is
in the OFF position when you
are away from home for long
periods of time.
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 5 under Lighting
Instructions, page 26.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow step 8
under Lighting Instructions, page 26.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page
40). Follow instructions included with the re-
mote control.
NOTICE: You must light the pi-
lot before using the hand-held
remote control unit. See Light-
ing Instructions
on page 26.
OPERATING FIREPLACE
Continued
1. After lighting, let pilot flame burn for about
one minute. Turn control knob to ON posi-
tion. Slide the remote selector switch to the
REMOTE position (see Figure 43). Note:
The burner may light if hand-held remote
was on when the remote selector switch
was last turned off. You can now turn the
burner on and off with the hand-held re-
mote control unit.
IMPORTANT:
Do not leave the selector
switch in the REMOTE or ON position when
the pilot is not lit. This will drain the battery.
Figure 44 - On/Off Hand-Held Remote
Control Unit (GHRCB)
Control Button
Turns Burners
On and Off
Figure 43 - Setting the Selector Switch
and Control Knob for Hand-Held Remote
Operation
OFF
ON
REMOTE
O
FF
PIL O T
O
N
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the hand-held remote
until burner turns on. Hold the control button
again until burner turns off (see Figure 44).
TO LOCK press both buttons on hand-held re-
mote control until light stops flashing. Hand-
held remote control is now locked. If the fire is
on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together on
hand-held remote control until the light stops
flashing. The hand-held remote is now unlocked.
Control Knob
Selector Switch in
REMOTE
Position (Optional
Hand-Held
Remote Control)
Electronic
Ignitor