Pt4000 – ikan PT4000 User Manual
Page 6
3903 Stoney Brook Dr. Houston TX 77063 | +1.713.272.8822 | www.ikancorp.com | [email protected] | © 2009 ikan Corporation. All right reserved.
10
9
PT4000
20” TELEPROMPTER
Attach your camera to the Metal Bracket on the 20” T-slot. To do so, first loosen each screw on the metal bracket and slide
it off the T-slot. Then, use either the ¼-20 or the 3/8 screw to attach your camera to the metal bracket (Some cameras may
require a washer or other spacer in order to fit snugly).
your
tripod
ikancorp.com
Washer (Not included)
** Some cameras may require
an extra spacer, such as a
washer, in order to fit snugly.
Part-E or Part-F
(depends on your camera)
ikancorp.com
> Loosen the screws and slide out the Metal Bracket
through the channels
> After attaching your camera, slide back the Metal Bracket
through the channels and tighten all screws.
camera
lens
metal frame
monitor
Use the Velcro strips to fit for three outer sides of the Prompter Glass Frame. Peel back the covering strips to expose the
adhesive and then stick the Velcro to the sides of the frame. This will allow the Hood to connect when you place it on the
assembled Teleprompter.
velcro
velcr
o
velcr
o
5 of 10