Induction Dynamics S1.iw - Manual (Page 10)

8 Audio Perfection Realized
™
Tools and Materials You Will Need
Stud Finder
Pencil
Drill and assorted bits
Level
Drywall knife or keyhole saw
Hand saw
1/4” hex key or hex driver
#2 Square Drive Screwdriver
Slotted screwdriver
Speaker cable (fire rated)
Flashlight
Level
New Construction Installation
In new home construction, or with walls where drywall has not been applied, it is
recommended that you wait until after the drywall application before installing the easy-
mount boxes for the following reasons:
1. The installer gains the control to cut a neat and accurate hole, eliminating possible
mistakes by drywallers.
2. Drywall around the hole is more likely to be flat. This is especially true if any mudding
is done in the vicinity of the hole. The result is a cleaner final fit around the edges.
3. Possible shimming behind drywall can throw off depth calculations and final alignment
of gasket with the face of the drywall. Drywallers sometimes shim to level out the wall
where studs are out of line.
4. Mud and construction dust is kept from getting into the box.
If circumstances require the easy-mount boxes to be installed prior to drywall, then be sure
the gasket on the front of the boxes protrudes out from the edge of the wall studs by an
amount equal to the thickness of the drywall plus 1/4”. Alternatively, the outside back of the
metal box should be 3 7/8” back from the finished drywall surface.
Check for Obstacles Inside Walls
Check the home’s architectural blueprints to verify that your preferred mounting location
is free from obstacles including extra wall studs, electrical wires, plumbing, and heating
ducts.