JLCooper ES-450SPE - Manual (Page 25)

25
Change the following parameters highlighted below in the eBOX
Settings section:
The IP Address parameter is the IP Address of the eBOX. You can
use any valid IP Address. In this example, we will use IP Address
192.168.200.115.
The Subnet Mask parameter is the Subnet Mask of the eBOX. If
the remote device (in this case, the ES-450) is not in the same
subnet as the eBOX, the eBOX will communicate through the
gateway.
The Gateway parameter is the IP Address of the gateway that the
eBOX uses when the remote device (in this case, the ES-450) is
not in the same subnet as the eBOX.
The TCP Port parameter is the TCP port that the eBOX listens on
for a connection from the remote device (in this case, the ES-450).
You can use any port except ports 23, 80 and 4141. In this
example, we will use port 23456.