Denon DN-HD2500 - Manual (Page 19)

14
ENGLISH
6
Stutter
• A1 and A2 points can be also used for
Stutter playback.
t To enable stutter playback, push
FLIP button for A1/A2 buttons,
then “
” display turns off.
Press the FLIP button to switch
between the Hot Start/Seamless Loop and
Stutter modes.
• If the device has been changed in the file
playback mode or if the playlist has been
changed in the playlist playback mode, the
A1 and A2 points are cleared by force.
7
Clear the A1/A2 point
y While pressing the FLIP/(CLR) button, push the
A1 or A2 button to clear the corresponding A
and B points.
Or push the FLIP button for more than 1 sec to
clear both A1 and A2 points at once.
Quickly pressing the “FLIP” button first and
then A1, A2 or B buttons will clear these points
individually.
Trim A or B point
e Turn JOG disc slowly to move
the A or B point 1 frame at a
time.
• Range for trimming A or B point is limited as
follows. ±30 frames of point A and up to 5
frames before point B
B point for Loop:
Between 5 frames after A point and file end.
9 A/B TRIM
w
,
r q
e
1
q When the A/B TRIM button is
pressed during seamless loop
playback, the A/B TRIM mode
is turned on.
To cancel A/B TRIM mode,
press the A/B TRIM button again.
3
2
Select A or B point
w Press the A1 or A2 button to
select point A. Press the B
button to select point B.
✽ The loop that can be adjusted is the
currently playing loop.
• The Seamless Loop A and B points can be fine-adjusted using the JOG disc.
• Trim the points during loop playback as a rehearsal.
A/B Trim
4
Save the A or B point
r Push the A button again to
save new A or B point, and the
unit automatically exit from the
A/B Trim mode.
ENGLISH