Kairak Undercounters (KU) - Manual (Page 8)

Undercounter Refrigerators and Freezers
PAGE 8
5. clEAnInG tHE condEnsER/
FIltER
(cont.)
5B - REPlAcInG tHE GAsKEts:
To remove the gasket to be replaced, grasp it firmly by one corner and pull it out. Before
attempting to install a new gasket, both the unit and the gasket itself must be at room
temperature. Insert the four corners first by using a rubber mallet (or hammer with a block
of wood). After the corners are properly inserted, work your way towards the center from
both ends by gently hitting with a mallet until the gasket is completely seated in place
(see figure below for proper gasket placement).
notE: the gasket may appear too large, but if it is installed as indicated above it
will slip into place.
5c - clEAnInG tHE cABInEt sURFAcEs:
WARnInG: dIsconnEct ElEctRIcAl PoWER sUPPlY BEFoRE clEAnInG AnY
PARts oF tHE UnIt.
Exterior stainless steel should be cleaned with warm water, mild soap and a soft cloth.
Apply with a dampened cloth and wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive cleaners as they may tend to mar
and scratch the surface. Do NOT use cleansers containing chlorine, such as bleach, this
may promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with water, containing chlorinated
cleansers, when mopping the floor around the unit.
For stubborn odor or spills, use baking soda and water (mixed to a 1 tbsp baking soda
to 1 pint water ratio).
A stainless steel polish is recommended for shining of unit.
VERtIcAl GAsKEt
REtAInER
InsIdE dRAWER
PAnEl
GAsKEt
AssEMBlY
FIGURE 4