Kanguru Mobile Clone 1HD Duplicator - Manual (Page 27)

27
8.4 HPA Check
The Host Protected Area (HPA), sometimes referred to as the Hidden Protected Area, is a partition
on the hard drive that is not normally visible to an operating system. Tap the ‘RUN’ button to change
this option’s setting.
• [ ] – HPA Check is disabled (default). The system will not check for HPA partitions.
• [ ٭ ] – HPA Check is enabled. When HPA CHECK is enabled the duplicator will support Host
Protection Areas. When you duplicate a Master HDD that contains HPA, the system will detect
the HPA partition, unlock it, copy the area and then re-lock the area once duplication is complete.
8.5 No Capacity Check
The duplicator has a built in capacity check function which will check the capacity of the Master
hard drive and the Target hard drive(s) during Full or Brief copy processes and determine whether the
drives’ capacities are the same.
Tap the ‘RUN’ button to change this option’s setting.
• [ ] – No Capacity Check is disabled (default). When a Full or Brief copy process is executed
the system will check the capacity between the Master and Target hard drive(s) to determine
whether the capacity is the same. If the capacity is different the copy process will be cancelled.
• [ ٭ ] – No Capacity Check is enabled. When a Full or Brief copy process is executed the system
will not check the capacity between the Master and Target hard drive and start the copy process
as normal.
8.6 Max UDMA Mode
The MAX UDMA MODE option allows you to configure the maximum transfer speed allowed. Tap
the ‘RUN’ button to change this option. The MAX UDMA MODE can be set as 0 – 5. The MAX
UDMA MODE is set to 5 by default.
HPA Check / No Capacity Check / Max UDMA Mode